The HCMH II Riggers Belt is a EN 358 certified belt for work positioning and fall restraint with connection points on both the front and rear of the belt that are rated to 15kN.

 

 The belt will fit through standard trouser belt loops so that it can be used as a standard belt but can be quickly transformed into a EN 12277 certified Sit Harness by adding the leg loops.

 

 The belt uses 2-part 316 stainless steel buckles coated in a very tough electrophoretic paint. The buckles have an offset, angled slot that increases security - these features make the buckle system very safe and very resilient to adverse environmental conditions i.e. maritime or tropical conditions.

 

 The belay loop is sewn from a very tough dyneema webbing that does not pick when in contact with velcro. The belay loop can rotate freely so that wear is not concentrated in one area.

 

 The belt has been designed to be compatible with several DMM gear storage accessories such as the Vault carabiners and Parking Lot storage adapters.

 

 Gear loops for racking climbing equipment when in the mountains are also available.

 

 Adding the HCMH Leg Loops turn the Riggers Belt into an EN 12277 certified Waist Harness and donning/doffing of the leg loops can be done with both feet on the ground. The legs loops can be kept stored on the Riggers Belt so they can be quickly added if required – the leg loops can be fitted and ready to use in 15-20 seconds.