Helix R3 Chest Harness
A single size, fully adjustable Chest Harness that was developed with input from end users. It takes elements from other Helix Chest Harnesses and combines them to give a low profile, modular Chest Harness that can be worn over or underneath plate carriers.
The main differences between the R3 Chest Harness and the C2 Chest harness are that:
-
A narrow, rear securing strap (not shown) connects the Chest Harness to the Riggers Belt/Waist Harness; this minimises lift and rise up when the Chest Harness is loaded and gives greater comfort whilst ensuring the Chest Harness and plate carrier stay correctly positioned.
-
The Chest Harness is broader across the chest – 30cm compared to 24cm on the C2 – this allows it to fit better when run over a plate carrier.
The R3 Chest Harness can be used in conjunction with the R3 Waist Harness to give a full body harness that is certified to EN 361. The Chest Harness can be fitted with two accessories that increase functionality:
-
A bespoke Chest Ascender can be added/removed to allow rope ascent. This has a long grab tab that allows easy use with cold, wet or gloved hands.
-
A high attachment point is built in which allows a bespoke ladder hook to be attached when required. This ladder hook is not only significantly stronger than any other model, but it can also be positioned to allow fast, hands free resting and then released cleanly when climbing again.
The front riser strap is adjustable and allows use on all sizes of end user.
The harness uses a mesh body that helps keep the load bearing in their optimal position. The mesh body improves performance and comfort but does not retain water like traditional padding. The harness is secured using a stage 3 buckle, that allows fast release but cannot be incorrectly or half connected.
